| Inverter Part |
| Collector emitter Voltage of Each IGBT | VCES | | 600 | V |
| Each IGBT Current, Continuous | IC | TC= 25C | 5 | A |
| Each IGBT Pulse Current, Peak | ICP | TC= 25C, Less than 1mS | 12 | A |
| Maximum Power Dissipation | PC | TC = 25C, Each IGBT | 23 | W |
| Junction Temperature | TJ | Note1 | -40~150 | C |
| Control Part |
| Control Supply Voltage | VCC | Applied between VCC and COM | 20 | V |
| High-side Bias Voltage | VBS | Applied between VB and VS | 20 | V |
| Input Signal Voltage | VIN | Applied between VIN and COM | -0.5~VCC+0.5 | V |
| Bootstrap Diode Part |
| Reverse Voltage | VRRMB | | 600 | V |
| Forward Current | IFB | TC=25 | 0.5 | A |
| Forward Current (Peak) | IFPB | TC=25, Less than 1mS | 1 | A |
| Total System |
| Self-protecting power supply voltage limit | VPN(PROT) | VCC=VBS=13.5V~16.5V, TJ=125C, <2us | 400 | V |
| Module shell temperature | TC | | -20~100 | |
| Storage Temperature | TSTG | TC=25 | -40~125 | |
| Isolation Voltage | VISO | 60Hz, Sinusoidal, AC 1 min, between pins and heat-sink plate | 1500 | V |
| Electrical Characteristics (TJ=25, Unless Otherwise Specified) |
| Inverter Part |
| Collector - emitter saturation voltage | VCE(SAT) | VD=VDB=15V, VIN=5V, IC=5A, TJ=25C | -1.95 | V |
| FRD Forward voltage | VEC | VIN= 0V, IC=-5A | -1.6~2.0 | V |
| Collector emitter leakage current | ICES | VCE=VCES, TJ=25C | -7.5 | uA |
| Switching Times (Turn-on) | tON | VPN= 300 V, VD= VDB= 15 V, IC=5 A | 800 | nS |
| Switching Times (Turn-off) | tOFF | VIN= 0 V 5 V, Inductive Load | 500 | nS |
| Turn-on loss | Eon | IC = 5AVCC = 400VVD = VDB = 15VL=1mHTj= 25C | 42~92 | uJ |
| Turn-off loss | Eoff | IC = 5AVCC = 400VVD = VDB = 15VL=1mHTj= 25C | 90~142 | uJ |
| Control Part |
| Quiescent VCC Supply Current | IQCC | VCC=15V, VIN=5V | 360~600 | uA |
| Quiescent VBS Supply Current | IQB | VDB=15V, VIN=5V | 64~120 | uA |
| Low-Side Under-Voltage Protection Detection Level | UVCCD | | 7.2~9.2 | V |
| Low-Side Under-Voltage Protection Reset Level | UVCCR | | 8.0~9.8 | V |
| High-Side Under-Voltage Protection Detection Level | UVBSD | | 7.2~9.2 | V |
| High-Side Under-Voltage Protection Reset Level | UVBSR | | 8.0~9.8 | V |
| HVIC Temperature Sensing Voltage Output | VTS | VCC=15V, THVIC=25 | 0.6~1.2 | V |
| Input ON Threshold Voltage | VIH | | -2.9 | V |
| Input OFF Threshold Voltage | VIL | | 0.8 | V |
| Bootstrap Diode Part |
| Forward voltage | VFB | IF= 0.1 A, TC= 25C | -4.5 | V |
| Reverse recovery time | trrB | IF= 0.1 A, TC=25C | 80 | ns |
| Recommended Operating Conditions |
| Supply Voltage | VPN | Between P and N | 300~400 | V |
| Control Supply Voltage | VCC | Between VCC and COM | 13.5~16.5 | V |
| High-Side Bias Voltage | VBS | Between VB and VS | 13.5~16.5 | V |
| Input ON Threshold Voltage | VIN(ON) | Between VIN and COM | 2.8~VCC | V |
| Input OFF Threshold Voltage | VIN(OFF) | | 0~0.6 | V |
| Blanking Time for Preventing Arm-Short | tded | VCC = VBS = 13.5 ~ 16.5 V, Tj 150C | 1.0 | us |
| PWM Switching Frequency | FPWM | Tj 150C | -20 | KHz |