This Building Material Non-Combustibility Tester meets the test standards of GB/T5464-2010 "Testing methods for non-combustibility of building materials", and ISO1182:2020 "Fire response test of building materials - non-flammability test" to determine whether the building material is non-flammable under the specified conditions.

Feature

1, Applicable standards:ISO 1182:2020,BS 476-4 & 11,ASTM E 136

2, Intelligent test system with Patent design;

3, Stainless steel burner, beautiful and easy to clean;

4, The heating furnace size: Φ95 mm × Φ75 mm × 150 mm;

5, 3 mm × 0.2 m Ni 80% Cr 20% resistance band;

6, Air cover: Φ75 mm × 500 mm;

7,Thermocouple:insulated nickel-chromium-nickel-aluminum Φ1.5 mm

8, Non Combustion Test Equipment has a power controller;

9, The temperature balanced time at 750℃ is about 35min~40min;

10, Thermometers range: 0 ~ 1000 ℃ ± 5%;

11, Non Combustion Test Equipment is equipped with mirror to see the internal of the furnace.

Control System

1, High degree of automation, test procedure safe and reliable, easy to operate;

2, Use high-quality strip heater, furnace temperature was raised to 900 ℃;

3, PLC control system + SSR temperature control system extending

the life of furnace:

4, PLC output signal to control the heating voltage 0-110VAC. Eliminate the influence of voltage fluctuation on temperature.

5, Temperature control: 750℃±2℃；Resolution:0.1℃；

6, The sample is move up-down into the furnace automatically by motor.

7, Computer controlled with Labview based software

8, Non Combustion Test Equipment adopts an audible alarm and alarm display functions accidents.

9, Equipped with printer, to print the temperature curve.

10, Two furnace thermal couple for furnace control and temperature record, location show in below figure, compliance with ISO 1182-2020,

11, Thermocouple with copper cylinder for furnace temperature calibration.

12. Furnace temperature calibration and wall temperature calibration

13.Non Combustion Test Equipment has standard and new furnace heating mode.